You may or may not have seen the documentation of my omnibot build (B.o.b. - Bret's Omnibot), but here he is completed. Bob's Mods: Camera, head turning, right shoulder articulated, left shoulder, elbow, wrist, and claw articulated, sonar, lighting, EL wire accents. I am just working on him here with my joystick gamepad, playing with different functions. But Bob is ready to go - and thanks for the salt little guy.
without further adieu - Bob:
By bret.tallent
— Last update
Discover more robots
David's Humanoid Robot
Robosapien V2 upper-body robot with homemade 7-servo arms and Micro Explorers story about tiny robots that combine,...
Leversofpower's Un2003a 28Byj48 Stepper Motor Project
Implement the UN2003A 28BYJ48 stepper controller for low-cost open-loop positioning; easy hardware setup; listed in...
Robohappy's Adventurebot4wd
4-wheel drive robot upgrade using four CR servos with Y-splitter cables to preserve directional control; camera, sensors...
I used and LED chaser circuit and randomly placed the LEDs. Then I tied that to an EZ-B digital pin to turn it off and on. You need to use a TIP120 transistor to do this. I posted instructions on someone else's link but can't find it now.
@bret This one? Link to thread
Thanks! That's the one!
Thanks for the response. I'll have to give it a try. Makes for a veryyyyyyyyyyyy cool display!!!!!!
Thanks
Super cool robot. Looks great black with all the lights flashing. I need to get more EZ Bs to make more of my robots smarter.