Hello everyone,
I would like to share the new custom firmware available for EZB 4.
Currently i'm beta testing the firmware fixing and polishing the code.
I'm still open for ideas, please comment.
- Initial screen:
- Access point configuration:
- Client/Station mode configuration:
- HOST/EZB configuration:
Ports Configuration:
Tools
Working in progress
I will describe in another post the new features.
By ptp
— Last update
Discover more robots
Tony1952's My Rolly Boxbot
Rolly: a Wall-E playmate on tracks using a 2WD Rover 5 base, EZ-B v4, ultrasonic sensor and JD head, dual LiPo batteries...
Rgordon's Magnus The 6 Ft Robot
Magnus: a 6 ft, 300 lb humanoid using wheelchair motors to drive tank treads; builder exploring E Z Robot kit and...
Steve's E4-B4 Build Diary. (R2-D2's Little Brother)
Build a custom Astromech Smartdroid E4-B4 with dual EZ-B v4 controllers, tablet chest, pico projector, 12V drive motors,...
Absolutely fantabulous work @ptp. I wish I had a programmer to load this firmware!
You pretty much hit the nail on the head for my initial ideas about what I felt could be improved in the web interface. Authentication being a big one!
Good job and keep it up!
Programmer is $14 clone off E-Bay... Well worth the investment to do this upgrade.
There is no ebay where I live, and international shipping to here is hit or miss unless you use DHL or similar.
(which is normally 3 times the price of the item) eyeroll
@PTP, Awesome work on this new firmware. I am working on indoor navigation project, is it possible you could add a way to view wifi access points and there signal strength? Also have this info available in ARC My hope is to use 3 APs signal strengths to triangulate my position.
RichardZ
Hello, when will this Firmware for Ezb-v4 be available?
This firmware is for the old discontinued EZ-B v4.x/1. The new EZ-B v4.x/2 has it's own firmware updater - which you most likely have the latest firmware if you've purchased it within the last few months.
Just stumbled across this...slowly getting used to the new forum!!
Great work @ptp