My robot friend aRTi began from about 20lbs of PLA. aRTi is a work in progress. I built aRTi to learn. There is a future in AI and robotics and I want to be a part of it.
By IntellamicroRobotics
— Last update
Discover more robots
Leversofpower's Un2003a 28Byj48 Stepper Motor Project
Implement the UN2003A 28BYJ48 stepper controller for low-cost open-loop positioning; easy hardware setup; listed in...
Ezang's Some Examples From The Past Of Glyphs, Glyphs With...
Glyph examples with augmented reality and QR codes using a USB camera and the EZB4 with camera and sample code
Rgordon's Project Magnus On Hold
T.E.C.H. humanoid with EZ Board brain, two-wheel tank drive, scooter chain drive, camera-ready head, voice control,...
Hello! Welcome. This is the place to be for robotics. Nice looking Inmoov, you'll find lots here. You've spent a bit time post processing the face.
Can you share what you used for the eyes? They look great.
Hello 3dGuy,
I purchased the eyes through amazon. I tapped the pupil to allow for the EZ-B v4 Camera.
Pair of Realistic Acrylic Eyes for Halloween PROPS
Thanks,
Mark
Thanks for the link. I didn't know you could buy them like that. T-one may be getting some new peepers.
Looks great and a nice tip on the eyes.
I think your inmoov eyes look cool, There is quite a few inmoov builders on Synthiam, if you ever need advice you will not have to look far. welcome aboard.
Your build looks good, and nice eyes! I see you have a way to go the complete your InMoov, enjoy. Have you or are you going to use the EZ-B controllers, there are a couple of folks on the forum that have converted over from the original Arduino build and never looked back. Programming your InMoov with the ARC s/w is so easy!