2 single motor controllers

Question

Just wondering if any one has run 2 single motor controllers instead of a dual channel H-bridge on their tank style robot and will it be hard to get both controllers to work with EZB 4 at same speed when moving forward/backwards? I ask because robot shop was out of the dual H-bridge I needed at the lower price range and I ordered 2 single 13-30 amp motor controllers instead at about the same price range.

Nomad 6R · Answer

maybe you can use two iotiny's in your project.

robo rad · Answer

I don't really want 2 Tiny's but I know I can use H bridge #1 and #2 in ARC, but hoping I can keep both motors running at exact same speed or else the robot wont travel straight.

DJ Sures · Answer

Just use the same wires on the ezb for both hbridge. You don’t need separate controls. Connect the wires together. It’ll be the same speed.

robo rad · Answer

Thanks DJ, great to know that as I already ordered the parts and then I thought oops, I should have asked about this first in the forum before ordering but it should work out well then.

robo rad · Answer

Hmmmm....interesting once I added the left motor single motor controller it worked with the buttons to go forward backwards and then I added the right side motor and controller and did the same but using the same H bridge software control in ARC had no PWM slow or fast and could only get forward working with both motors at the same time, Left and right work but only one motor at a time instead of 2 going in opposite direction(circle motion) I thought this would be a simple wiring sollution but I guess using 2 separate motor controllers needs to be wired differently than the old dual motor controller I had before. This will take more time to figure out than I originally thought.It could be just a ground wire issue too and I may need to make 2 PWM input separate channels instead of the one I had connected together before.

robo rad · Answer

So this is what I have but 2 of them to control 2 motors on a left right tank. I just need to figure out the EZB output pins to the Dir,Ground and PMW pins on the controllers instead of connecting to Arduino to EZB signal pins. The wiring seems slightly different from a dual channel L298 H bridge so I am needing to change some wires around for signal inputs of 2 separate controllers instead of 1 298 h bridge.

robo rad · Answer

And this video is exactly what I am doing but with EZB instead of Arduino,so I just get confused with the old EZB signal pins I had were 13,12 and 15,14 with pin 16 as my PMW in a y connection so it controlled both motors on the older L298.

ptp · Answer

Quote: I just need to figure out the EZB output pins to the Dir,Ground and PMW pins @RoboRad, The 4 wire PWM Bridge/Movement Panel is not compatible with yours.  Use a custom movement panel to control your 2 PIN H-bridge.

robo rad · Answer

OK thanks PTP pointing me in the right direction,will try that out!

robo rad · Answer

All righty now, Just had to remember to also add the sleep and Halt command instead of stop when changing direction or else the motor will continue to turn and not stop,even if EZ controller is disconnected! Now it will change any direction I want from custom movement panel. Actually much more easy than the L298 hbridge to wire up and control. Me likey....More power now and torque  running with the cytron window lift motors and a 12 volt 18 Amp/hr motorcyle battery.

robo rad

2 Single Motor Controllers

Upgrade to ARC Pro