Topic about 3d printing. How to start with 3d printing.
By Nomad 6R
— Last update
Discover more robots
Aerius's Inmoov Project
InMoov humanoid "ROBOTO" build in progress - a promising custom robot, paused for summer with scripting and...
Nitrobot's The Six Alternate Power Source
DIY battery upgrade for Six robot: swap 1300mAh for a 5000mAh Traxxas pack for ~4hr runtime, custom connector and...
DJ's Imperial AT-AT Walker Robot - The Force Is With Me!
Build an Imperial AT-AT walker robot; adding knee servos tomorrow to teach it to walk as a return to robotics.
thingvers owl
hi perry
about 10 houres.
top bat case bottem case i always wanted to make a batterie case.wel and i did.
there are two parts ,one slide in the other.there is a pin and hole in the back. there is room for a tiny screw ontop or a tire wrap in front.as in pic. the case is a little bit bigger then the lipo batt.just incase it chould swell up. printing time is about 2.5 hour per part.i hope you all find it usefull.merried owls
hey perry look at this koppel.so awesome.