This is the most updated model of the LEVi Platform
By jstarne1
— Last update
Discover more robots
Ezang's New Mr. Metal Robot 2020
Build Mr. Metal robot with Synthiam ARC using EZb4 controller, EZrobot 1300 camera, four EZ 360 HDD servos, Servo City...
Toymaker's The Latest ALTAIR Robot - SCAMP
SCAMP Assist-Drone: low-cost telepresence robot for elderly and disabled with telescopic reach, object fetching, Alexa,...
Thetechguru's Long Lasting Roli
Extend Roli's runtime for NMS experiments with a 7200mAh internal battery installed after a precise Dremel mod, boosting...
While waiting on the drawer to print, I started slicing up the main body into printable pieces. The main body is 14 pieces and the top cover is 4. The rear drawer was broken into two sides that are printing now.
https://www.thingiverse.com/thing:4031686
For development purposes you are welcome to print along and make your own if you have the patience.
non commercial use only, for personal use and you may contribute with modifications for your own use, if they are cool enough we could make them official.
the two drawer halves are printed after 34 hours and a heart attack because I thought I was going to run out of filament. I noticed the rear looks like butt cheeks of the robot.
The number 1 and 2 pieces of LEVi are printing. These are the pieces that the rear drawer butts up to. You can see the rear tail light support if you look close enough. These should finish in about 5 hours.My bday is Fri the 13th this year!
Just do me a favor Josh and don't go near Elm street
But but but, that’s my street:(