Custom Servo Controller
— Control up to 99 servos over serial with Vx virtual ports using custom firmware on Arduino or microcontroller controllers.
Try it →
This project has evolved some , the basic rundown is I'm modding two Omnibots , one a regular the other a larger 2000 model. I will have two ezb kits , rad base idea was thrown out because of so much noise but could go back on the table if the omnibot drivetrain is too weak to pull it.
Other projects from the same builder.
Robots the community built with Synthiam ARC. Get ideas for your next build.
Good Work Josh! Looks like you are getting it done.
Mel
Ok update , I'm filling the holes and gaps will rage gold body filler.
You can see the path through the tube I made lines up very well , I bet.it flows even better than the original 90 degree turn it had.
Are you looking at me? Just playing around neck is not attatched.
A line of ca glue with medium thickness can takes a couple hours to cure so I'm leaving it to harden tonight. The robotzone servos for the shoulders are here Tommorow meaning I can start cutting to make those fit. Wed is my day off so it will be a busy day for sure. On the bottom half Sam is helping make a riser! Thankyou!Yep he is looking at you and smiling inside at what you're doing for him.
Can you imagine what my second robot will be? Lol , I'm doing everything I can o make him about as awesome as I wanted when I was a kid (except I didn't drink beer then) , tonight I didn't feel that productive, I guess bondo and glueing things takes up a lot more time than one would think.
I'm sure your next will be just as great! Will it make your meals and do your grocery shopping?
I want one that cooks.
Looking good Josh.