UBTECH Alpha Servos UBT-12HC
— Control UBTECH Alpha UBT-12HC smart servos via ARC using EZ-B v4/IoTiny UART, assign virtual ports, set baud, custom bits and position mapping.
Try it →
This project has evolved some , the basic rundown is I'm modding two Omnibots , one a regular the other a larger 2000 model. I will have two ezb kits , rad base idea was thrown out because of so much noise but could go back on the table if the omnibot drivetrain is too weak to pull it.
Other projects from the same builder.
Robots the community built with Synthiam ARC. Get ideas for your next build.
Ok pololu.com high torque power HD servos came in
Woo hoo... I love getting goodies in....
yea me too.got in 5 boxes today,going to do a lot of robot hacking next week
Yup , now I guess ill get the two robotzone shoulder servos if I descide to do that and I guess I'm good on equipment lol. I need to attatch the vacuum to Jarvis back panel now and mod shoulders and upper arm for servo mounting. After the vacuum is mounted into jarvises back then I can do the mid section riser , I just need to make sure I make everything large enough.
Yeah maybe it's time for a test fit before you raise it.
Ok so the speakers I had before required a amp , I tried a pair of speakers which was 5 total watts but they were powered off USB and I don't think they were loud enough. Since much of Jarvis is about entertainment I'm installing a lightweight pioneer cd player I have which is new sitting around. 14 watts EMS , draws about 3 amps.
That's pretty awesome. Little remote and all. Will that hook up to your mini itx?
why not just use a cd player for your itx and get a low cost amp for it,i think the one i have for 50 watts,this way it plays music from your computer and plays cd's too