Network Change
— Execute scripts on WiFi/network connect or disconnect; monitor adapter, store status in a variable and trigger custom scripts for headless SBC robots.
Try it →
This project has evolved some , the basic rundown is I'm modding two Omnibots , one a regular the other a larger 2000 model. I will have two ezb kits , rad base idea was thrown out because of so much noise but could go back on the table if the omnibot drivetrain is too weak to pull it.
Other projects from the same builder.
Robots the community built with Synthiam ARC. Get ideas for your next build.
The Bondo is just a filler , I planned on backing this with epoxy , then a couple layers of fiberglass , the filler is here instead of fiberglass because its ten times easier to sand for paint. The glob you see on the outside of the shoulder is to fill the original screw hole that attatched the shoulder , I will have a cool S logo here.
Good forethought on the neck. Great looking progress as always!
Hey Josh, I have some 3" flexible duct that is very strong yet very soft and bendy that could work for your neck or shoulder joints. Interested?
Hey Bret. I may be interested in that blue duct if the black I ordered doesn't work out. What is the inner and outer diameter?
Inner is 2 1/2 and outer is 3". It is a high strength vinyl with wire coil. Kind of like dryer vent duct but a lot stronger. It was just a little too big for my B9 build.
Ah cool. This is the one I ordered. The outer diameter is a little smaller. if that helps you let me know. 2 1/2 to 2 3/4 black.
Link
J.... It's looking awesome.
i ordered a few sizes also from same company for my design i think i buy from from mcmaster carr then any other place,they all the robot needs