Stepper Servo
— Control up to 127 stepper motors via Arduinos mapped to ARC servos; supports any stepper driver, serial network, home calibration, speed/accel.
Try it →
This project has evolved some , the basic rundown is I'm modding two Omnibots , one a regular the other a larger 2000 model. I will have two ezb kits , rad base idea was thrown out because of so much noise but could go back on the table if the omnibot drivetrain is too weak to pull it.
Other projects from the same builder.
Robots the community built with Synthiam ARC. Get ideas for your next build.
lots of stuff off topic on this post ,i just have too many robots made and hard to take photos of them BUT will post more in a new thread,so others can use my ideas i mostly made high tech robots until i found the EZB and forum and stating to hack toy robots for a better design
Jarvis takes a trip to California! To go visit aunt Sam
Sniffle - they grow up so fast I wrapped him up in 6 layers of bubble wrap and left a bit of play to make sure he won't get squished in transit. It was sunny when I dropped the package off at ups but now to looks like a hurricane is moving through. But we need the rain this 107 degrees outside is for the birds!
Sam I know you wanted your torso to twist so I sent the neck twist gearbox that should fit in your neck hole of the omnibot frame fine. I sent lots of LEDs to light him up , a lynxmotion servo tilt bracket , hard drive bracket and spreakers you may want.
I sent 20 resistors you solder onto the positive led lead and allows them to be connected directly to 12v power source no drop down needed.i see a set of keys ,i guess she gets your car too lol
Hey, I want a car! Jarvis is getting close Josh.
Thanks Brett , have any extra of that tubing I could cover my shoulders with? Now once I get Jarvis back I just got to finish the vacuum being installed,
Yeah, I can send you a couple of feet.
I an auntie.....