EZ-B V4 Info
— Displays EZ-B v4 internal temperature and battery voltage, shows built-in battery monitor and LiPo protection settings in Connection Control.
Try it →
This project has evolved some , the basic rundown is I'm modding two Omnibots , one a regular the other a larger 2000 model. I will have two ezb kits , rad base idea was thrown out because of so much noise but could go back on the table if the omnibot drivetrain is too weak to pull it.
Other projects from the same builder.
Robots the community built with Synthiam ARC. Get ideas for your next build.
Hey Josh, I just posted a video of my arm design working. What do you think?
@sfoy i bought the same screen awhile back,there is 2 ways to hook it up one get usb to video ouput or like i have on mine video output on my itx computer
Yea Brett it was really cool , I think you got it!
Sam- yea I was looking to get that screen I just never did. I have a 7 inch I was thinking of using. There are VGA to composite video converters and like @robotmaker said there is USB to video adapters too. My most recent diagram I posted but I don't have it on my phone to send you at the moment.
@JOSH thats the one i am talking about in my reply also some video cards also have one too video onboard always has the best video output,itx board i have very small has a composite video output,so no adapter is needed, when you use video adapters there is signal loss and speed,so best is to use a on-board video with composite output or a video card with one
Josh, when I get off work I will get a better picture for you to show the arm mount I had.
@glickclik ,you must work real late from where you are i work at home now,called freelancing for company i work for
Thanks troy! I'm at Wal-Mart now in line to get epoxy and masking tape.
Fun with.letters! These are refregerator magnets , I can trim them just a little and glue them on.the base , sorta like a 3d name tag!