OK pretty simple idea here. I have noticed actual project cases are usually very ugly and very expensive. Then even if you find a good deal it may be very difficult to get a similar or matching case later. Ooooh the problems today's nerds face right? Here I will show how I used 12 dollars worth of used and probably broken routers , a dremel and a few drops of super glue to make a cool case.
. I will use it to house a light , fan and ezb but you can customize your application!
By jstarne1
— Last update
Discover more robots
Nomad's Using Robosapien V2
Customize V2 robot with EZ-B4: left shoulder camera synced to head rotation and right-side laser for shooting balloons;...
Cardboardhacker's Rover Ad
Dewy, a tall robot built from RAD parts modeled after an Omnibot, showcasing teardown steps and rebuild photos.
Steve's Captain Proton Startrekvoyager Tribute Robot.
Captain Proton tribute robot built from Meccano with EZ-Robot EZ-B and HHD servos, LED eyes/mouth, PWM drive, plasma...
Most routers have useful tidbits inside them to. And they just look good with the air vents, good idea.
Yup I robbed the antennas and DC jacks from them too
Those antennas could be really good to extend/improve the range of your cameras and the EZ-B. I am doing something similar on my Gunslinger Bob.
It would be nice to make a small amp circuit to boost ezb Bluetooth to class one power range... Then have a little antenna like this.
You can make or buy a little op amp for less than $5
Nice work. It has a real professional and chrome/metallic-like look to it. A great way to turn something ok into something really great.
There many parts in routers,and boxes are great,so far i dont think i have any bad yet
On my linxsys routers i get i turn them in to a very powerfull router using LINUX check dd-wrt site its free ,and all you need is a heatsink and fan,and some changes and firmware update and then i sell them on ebay,others are doing the same.
It makes them lot faster