Hi all
I have a made a new 2 DOF quad.
He is called Crabio 1.
I only have time to add a video about him for the time being.
I will post more pictures soon.
His walking pattern is abit noobish but i will fine tune him later:)
enjoy for the time being:)
By iskandershah
— Last update
Discover more robots
Tony1952's My Wall-E Powered By Ez-B V4
Control WallE with EzB V4 and EzBuilder: continuous rotation servos, tracks, WiFi, voice, face tracking, scripting and...
Bmcnamee1's Extending Jd
3D-printed male/female servo spacers extend JD by 2.75 inches, increasing leg reach and dramatically boosting speed with...
Cardboardhacker's Alex Cardboard Omnibot Twin
Build ALeX humanoid robot - 4.5ft, lightweight frame using servos, ez-B camera, 12V motors/battery, recycled materials...
Hahah
Wait for my next video.. i am sure it will be as entertaining:)
He can now run, lean, kick a ball and sits:)
This is a very exciting robot! Very good work
I know everyone would love to see your ARC Project File if you're willing to share your hard work
Cool robot! Good movements for such low DOF.
Hi guys!
as requested by DJ Sures, here is a overview about my ARCs.
And Crabio One Learns new tricks!
watch it!
Please comment:)
Man you did a great job!!!!!
Hahah Thank you DJ Sures !!!
As you can see on the last part of the video, Crabio Started losing power and falling to the ground.
Does that mean that the board has been over worked? any way to counter this? I am using a DC 12V bench power adapters..
Please advice.
The 12v bench power adapter from EZ-Robot? That should be good - but there are a lot of servos and the voltage regulator may be getting a tad too hot. It'll shut down when it gets too hot.
Amazing ! Good job !