Well it's never really complete right?
Here's my first (whew!) fully working droid, "Archetype". As you can see its somewhat EZbit "friendly" so room for expansion is possible.
I hope you all like my style...back to the old way of doing things, without 3D printers. Having said that, I have to credit Richard R for the ezbits.
Enjoy, and comments and suggestions are appreciated!
As of right now, I can't use everything at the same time, since it causes the ezb to brown out. I have also done the super cap fix, although it helps, I still only have a 2 amp voltage regulator running everything. That's only temporary of course. Once I get a higher amp battery I'll post some videos.
By Doombot
— Last update
Discover more robots
Joseph4760's Project X-Men
Project X-Men: EZ-Robot custom builds, modified tank with IP camera and sensors, Brookstone Rover, RAD 2.0, Ghost Rider...
Ezang's New Video - Using Floor Map And Touch Path Maps And...
Floor Map, Touch Path and Navigator enable simple path following; IoTiny hotspot guides your car-Intel RealSense...
Jeremie's Treat-O-Matic 2020
Convert a claw-style candy machine into a contactless Halloween dispenser with Atomic Pi, Arduino EZB, camera, PIR,...
@Robot Doc , @JustinRatliff
Guys, I can't thank you enough! Working on the video! I'm just finalizing the drivetrain on this thing, so a few minor changes may occur.
Update: I found a cost effective laser diode that'll kick @$$.