Exosphere — Telepresence and remote control for any robot with human-assisted tasks, video, audio, and AI training via ARC and mobile devices Try it →

Charel

Netherlands

Asked Jun 2023

4 Participants

I2C Problems, What Could It Be

Skip to comments Jump to end

Recently I got again I2C problems, EZ-B starts hanging even on a simple I2C write. Very frustrating.Checking all that changed, cabling. etc. Also, a new SW release could be the culprit. Has anybody experienced I2C issues since the latest release? (2023.06.09.00)

Jump to end

Upgrade to ARC Pro

With Synthiam ARC Pro, you're not just programming a robot; you're shaping the future of automation, one innovative idea at a time.

Compare Pro Features View Subscription Plans

Charel

Netherlands

#9 Jun 2023

Found the culprit, one of the Arduino's wasn't responding, causing the EZ-B to freeze and kill the whole robot. Nasty but at least found the rootcause. I have tried a cabled EZ-B connection and a WIFI EZ-B connection, in both cases the EZ-B freezes. For now, I have commented out the I2C write command. Would have been nice if ARC just responded with an error/exception message instead of "hanging". Anyhow, it was not the ARC SW release.