Is there a way to put the stop back in a continuous servo so it can be used as a rotation servo?
cparks328
USA
Asked
— Edited
1 Participant
Dual-Axis Compass
— Dual-axis I2C magnetic sensor for EZ-B robots enabling magnetic direction sensing; requires short 2-3 in wiring. Third-party hardware.
Try it →
It maybe possible but I am going to say even it it were it would not be worth the effort... just buy a regular servo if you need one.... Servos are dirt cheap anyway...
It's not just that the physical "stop" has been removed but also the electronics/pot have been modified as well...
Ok, thanks Richard, I figured it would be something like that, just thought I'd ask.