Robot Programming Questions and ARC Help

Suggestions On Gripper Orientation For 3D Printing

Any suggestions on the best orientation when 3D printing the gripper?

Bremerton Washington Kitsap Create Robotics Group And Upcoming Stem Faire

Hello DJ, I took my Adventure Robot creation to the Kitsap CREATE (Computers, Robotics, Electronics and Art Technology Enthusiasts) and did a demo on the EZ-Robot Concepts. It was a huge success and a lot of interest was generated in EZ-Robot Products. They were awed by the hardware/software and how easy it is for kids, beginning robotic...

Order Ez-B

When will the EZ-B5 be released? If I order an EZ-B Wi-Fi Controller today will I get an EZ-B4, EZ-B4/2? Are you taking 'pre-orders' for the EZ-B5? Thank you.

Making Android Mobile App Compatible With Multi-Screen Viewing On Android Phones

Hello DJ, I mentioned in a previous thread about having An IP Cam and EZ-Robot Cam mounted on IRobot Create for security uses. I also mentioned that I could switch between apps to view different camera views. Then today I found out that on the Samsung Galaxy S4 and other phones you can display two apps on the screen at the same time. This would be...

Ping Sensor

i just connected the ping sensor with the radar scan,problem i hear a , knispering sound comming out the sensor. is it broken ?

Ezb4 How To Work With 7.2 - 8.4 Volt Servos?

Hi, Anyone can help to answer my question that Ezb4 how to work with 7.2 - 8.4 volt servos? I brought 2 big servos and it need 7.2-8.4 voltage power. But ezb4 just provide 5 voltages. So, I brought "meanwhile" 7.5 volt external power supply. So, what can I do to make and connect it work? Thanks for your attention! Ricky Ma

Ax12 Led On/Off Command In Ez Script

Hello, I set up one of my dynamixels tonight, used the plug in, wrote scripting to "exercise" this servo. All works fine. In EZ script there is an instruction AX12Led(port,on) and AX12Led(port,off). I cant make either of these work. Using the plug in I can turn the LED on the servo on and off. Is there a way via scripting to do this....

Tutorial Improvement

i just read the tutorial off the ping sensor.what i notest is the pic off the, ezb how its wired up is hard to see.also it dont mention where the , in or out off the 5 volt regulator goes. i believe its in goes to ezb and out comes from the sensor ?is this correct ? ping tutorial

Ok Who Changed Things While I Was Gone?

It's been a while since I had time to work with my bots and when I recently updated my software lots of things broke! For example commands with parenthesis no longer allow for a space... Eg. Speak_("Hello) is now Speak("Hello") Now I can fix that easily enough... but what happened here: $Volume=$Volume-25 if ($Volume=<5)...

Foscam F19831p Useage With ARC & ARC Mobile

Hello All, I searched on the forums for Foscam Posts and found some good ones. However, the setup doesn't work for me. I know the IP Address of the IP Camera and it is on the same network that my robot is on. I entered the IP address into the camera selection field in ARC and started the camera but no video stream. I have the Foscam camera set to...