EwgBPwKcw0cz!~~60_1-634877148220156250.jpg)
EwgBPwKcw0cz!~~60_1-634870572001250000.jpg)
Ok this is the third of a trio of robots made to run around outside with first person view ez robot wireless cameras. Each has airsoft automatic guns and some kind of dart launcher.
By jstarne1
— Last update
Discover more robots
Mitzeljk's Meet Modi
Modi mobile voice-recognition robot controls a computer via EZ-B scripting and H-Bridge, built on an RC car base from...
Bret's Next Hack - Robot B9
B9 Trendmasters RC toy hacked: chest LEDs, flashing circuits, rotating antenna sensors, EL voice plate, bubble LEDs,...
Johnnybib's Ezrobot Myo Wii Remote Controlled Robot Arm
Motion-controlled robotic arm built in 20 hours using scrap metal, plastic, a Myo, Wii Remote and Synthiam ARC-hackathon...
Hope it holds for you.
If it doesn't , no worries. I will buy lock tite for rc racing motors. Before doing that however i may consider upgrading to higher voltage / torque motors.
Team starnes gets the first shirt made . This is a tester. If I like it I will have a better one made and add ezrobot logo .
Dude! Lookin' gooood.
Thanks bret! Im still trying to figure out whats happenning in this gearbox. I took it out agian today to play with and noticed that one side still sounds like the pinion breaks loose or something. Now it just makes a spinning noise and nothing moves. Really weird. So I may need to get lock tight for plastic pinions to hold this little guy one. In the mean time im looking to buy spare rad base for the gearboxes just in case this one gives me problems.
Tiny update : Its my Birthday! Woop woop! Besides that awesome news dispite a drop of ca on the pinion it still broke loose and spun freely . :/ I may need to rough up the shaft with 60 grit and put lock tite on there. Up until the pinion breaks loose everything runs smooth. I may switch to a l298n motor driver because I don't like the constant armed beep /tone from these controllers..
Happy Birthday and I hope you can get it running smooth again!
Happy Birthday Josh!