It's just a concept right now but I wanted others to see that the scale doesnt quite match. Right now its just stacked on there and neck is a little too long.
By Troy
— Last update
Discover more robots
Edison2's Spy Robot V2!!! Here It Is! The New Version!
Spy Robot completed and showcased at a school science fair, credited to DJ Sures; photos and Spanish materials from...
Sudo's Shogun V2
Shogun humanoid's redesigned knees reduce bend and boost load capacity; EZ-B and camera repainted; ready for walking and...
Buratino's Basilio
Basilio 45cm 3D-printed walking robot with 26 DOF, external potentiometers for pose capture, seeking EZB/EZ Robot...
It looks like the easiest solution for now is to try and get original motors and gears for the claw. Anyone here not using original setup? Id buy them.
I have some dc motors from robosapien. Think you could use those?
Samantha
These are what power his legs, then I also have whatever is in his arms and waist.
Thanks Sam but I actually need the gears more. Josh and I are researching DC replacement motors. I found these and ordered them to test out. They can operate up to 12v normal and down to 4.5v.
Ebay link
Hey Bret.talent, can I get 4" of that blue duct?
Sure, just email me your shipping info. [email protected]
sa-280 not a bad motor ,but RS-380 has more torque and a very common motor in robotics
@Bret. Thanks! I really appreciate it. Let me know if I can help you out too.
@robotmaker, True. Those are good but the issue was trying to get them to fix in the arm's original motor mount area. RS-380 is longer and larger diameter and wouldnt fit there. Even the RC-280 isnt a perfect fit but I think it may be workable. Idk yet until it comes in. The proof in the pudding will be if the axle sits correctly for the gears to mesh. I figure anything is better than what's in there now.I will let all know after I test it.