Since my robot is running on a Raspberry Pi, which is now supported by ARC, I decided to evolve my current project K[8] into a new one called ZOE... First steps will creating a new servo setup which supports Dynamixel Servos, and a new Conceptual design!!
By Mickey666Maus
— Last update
Discover more robots
Bhouston's A New Dof For Inmoov's Neck/Head
New InMoov neck mechanism adds an extra degree of freedom, improving head articulation; prototype needs fine-tuning.
Ericez's Droid For Theater Robot Contest
Build low-cost BB-8 and R2-D2 Star Wars robots from PVC water pipe and control them using an EZ-Board.
Jstarne1's Holiday Video U Command Wall-E And Sled Buildup
Walle robot races on a sled to fetch a Six EZ Robot package for Christmas with rocket-like flames, landmark shots and a...
Noma d where are you?
come back and try it mickey
@EzAng.... Time zones EzAng, there are 24 of them... It is 2:13am in Germany at the time of this post.... Maybe they went to bed?
Hey Nomad, maybe you should modifiy the stand for ZOE a little bit befor printing, because the body will be a little lower that the level of your base! It will also work your way, but I will be building a new body soon which also holds the speaker and Neo Pixel, so maybe it would be nice to have some room available...kind of like this!
Because the body will surpass your floor level...its kinda like this!!
hey mickey
good idea i can make an extra block as in your picture.
what about this idea?lots off spare room.little smaller then the lower block.
Sure, looks good...I am making a test print to make sure everything works out fine, then I will send you the new part so you can check if it works with your design!! It looks like this...