Since my robot is running on a Raspberry Pi, which is now supported by ARC, I decided to evolve my current project K[8] into a new one called ZOE... First steps will creating a new servo setup which supports Dynamixel Servos, and a new Conceptual design!!
By Mickey666Maus
— Last update
Discover more robots
Mac's Irobot - Scuplture
Sculpture inspired by Asimov's I, Robot explores robots protecting humanity; face-tablet shows human faces and clips of...
Fxrtst's Project Gargantua (Or Gar)
Hexapod centaur robot with arm cannon, 53 PETG 3D-printed parts, 23 servos, 7600mAh LiPo, EZ-Robot servos, EZB, onboard...
Gary's RALPH
Multi-lingual InMoov (Drupp neck) using adaptive AIML to switch languages and voices, plus facial recognition for...
@PTP
you sure have a point about the crazy stuff
haha.
ez robot controller would be fabulous if we can use that.
lookin forwart to your topic.
thank you
the stl original from the zoe head frame is 1.5 mm higher and 1.5 mm weider. as you can see the frame is 1.5 mm too high and to weid.
i have seen this before with other parts.i gess the cura or TC is not so accurate.
This is very strange...can tell me which slicer software you are using, so I can confirm I am getting the same result?
i am using cura 4.5.0 there is another strange fenomen with cura.when starting up cura,all works fine, except the copie&paste funtions stopped working.you have to reboot to start working again.
Check in Windows so I can see we are having the same numbers...
Which printer are you using?