Since my robot is running on a Raspberry Pi, which is now supported by ARC, I decided to evolve my current project K[8] into a new one called ZOE... First steps will creating a new servo setup which supports Dynamixel Servos, and a new Conceptual design!!
By Mickey666Maus
— Last update
Discover more robots
Stiko's Henry The Enchanted Tree
Bring an Enchanted Tree puppet to life with 3D-printed parts and an E-Z-B V4 camera to animate arms, mouth and eyes.
Jeremie's Voltron Robot
3D printed walking and talking Voltron robot built from Juri's 3Dworkbench design-100+ hours printing, ~$100 filament,...
Johnnybib's Ezrobot Myo Wii Remote Controlled Robot Arm
Motion-controlled robotic arm built in 20 hours using scrap metal, plastic, a Myo, Wii Remote and Synthiam ARC-hackathon...
@PTP
you sure have a point about the crazy stuff
haha.
ez robot controller would be fabulous if we can use that.
lookin forwart to your topic.
thank you
the stl original from the zoe head frame is 1.5 mm higher and 1.5 mm weider. as you can see the frame is 1.5 mm too high and to weid.
i have seen this before with other parts.i gess the cura or TC is not so accurate.
This is very strange...can tell me which slicer software you are using, so I can confirm I am getting the same result?
i am using cura 4.5.0 there is another strange fenomen with cura.when starting up cura,all works fine, except the copie&paste funtions stopped working.you have to reboot to start working again.
Check in Windows so I can see we are having the same numbers...
Which printer are you using?