This is a WIP of a cycloidal gearbox with a reduction ratio of 40:1. It is driven by a Tarot 4108 brushless motor, in theory it should have almost zero backlash...
By Mickey666Maus
— Last update
Discover more robots
DJ's Detect Multiple Colors
ez-robot camera detects faces, objects, glyphs, QR codes and colors; works with JD Humanoid and any ez-robot...
Mickey666maus's Oled Animated Eyes For ARC Pro And ARC Free
Control ItsyBitsy M4 OLED eyes from Synthiam ARC via serial: flash firmware, send animation numbers over COM ports and...
Imrisaac's Ez-B Project V3.0
Surveillance tank with EZ-B and XBee XSC900 for long-range control, Android IP camera streaming video, Vex treads,...
Good find!! I will take a look!!
This is another take on a strain wave gear, it works with a belt! I am not sure if this is the better choice over a printed one...but it would surely offer all the needed material properties needed for that part!
This is a nice take a a 3d printed strain wave gear, but seeing the noise and vibration makes me afraid that it might be better to stay within the cycloidal realm of gearboxes?
What do you guys think?
So I got the gearbox setup with the encoder working...it is actually less vibration than expected, I will make more stress tests under load!
Looking good so far!!
Also ARC integration is super easy!!
Nice job! What did you print your parts with?
Its all ABS...
What was the approximate cost for the parts?
Looking forward to your torque testing.
I used an Odrive and the recommended controller from their site...
The motors and bearings were ordered from China, do quiet cheap but as we all know...its a waiting game!!
I think the cost should be less than 150 per joint!!
But a 3d printed gearbox still is a 3d printed gearbox after all...lets see how it'll hold up during some stress tests!!