This is a WIP of a cycloidal gearbox with a reduction ratio of 40:1. It is driven by a Tarot 4108 brushless motor, in theory it should have almost zero backlash...
By Mickey666Maus
— Last update
Discover more robots
Wallekid1's Wall-E Made From Scratch
WALLE replica: custom reinforced tracks, moving arms and neck, independent track drive, LED eyes, random sound notes,...
Bhouston's Robotic Arm
Robotic arm overview highlighting design, capabilities and operation; creator available to answer inquiries and provide...
Morbeious's My Printer Revolution Six
Custom Revolution Six robot dances after 3D printer and wiring fixes, ready for scripted dance routines.
Good find!! I will take a look!!
This is another take on a strain wave gear, it works with a belt! I am not sure if this is the better choice over a printed one...but it would surely offer all the needed material properties needed for that part!
This is a nice take a a 3d printed strain wave gear, but seeing the noise and vibration makes me afraid that it might be better to stay within the cycloidal realm of gearboxes?
What do you guys think?
So I got the gearbox setup with the encoder working...it is actually less vibration than expected, I will make more stress tests under load!
Looking good so far!!
Also ARC integration is super easy!!
Nice job! What did you print your parts with?
Its all ABS...
What was the approximate cost for the parts?
Looking forward to your torque testing.
I used an Odrive and the recommended controller from their site...
The motors and bearings were ordered from China, do quiet cheap but as we all know...its a waiting game!!
I think the cost should be less than 150 per joint!!
But a 3d printed gearbox still is a 3d printed gearbox after all...lets see how it'll hold up during some stress tests!!