So I see a lot of wall-e's around
That made me thinking, it's time to show my wall-e
I started with the small wall-e ( the interactive )
What i learned from him i put in the big wall-e ( a U-command )
I used the old board from the wall-e for the sounds.
made the bot in 2 parts the upper half is full with servos..... and a sensor
And off course a good accu-pack is used for hours of fun ( 2,5 to be sure )
And that all together in a small compartment
So i proud show you all my wall-e and a lot of thanks to DJ ,radmeck and bret.tallent for helping me!!!
By Pabi!o
— Last update
Discover more robots
Ezang's Robot With Audio Voice Command And Audio Response
EzAng robot with audio voice command and audio response enables voice-controlled operation and spoken feedback
Redzone's Gideon Inmoov
Redesigning Gideon's lower body using four EZ-B v4 controllers to separate body parts, relearning commands and crediting...
Charleybot's Project Multi-Omnibots 2000
Upgrade Omnibot 2000s with Mini-ITX PCs, 12V battery power, servo-replaced arms, L298 motor controllers, USB Lifecam...
Hope you can see it in the picture. What i did was use the old connector from the main board to the small extension board
I split those is 2 groups one for the record-play-button to make a sound the other 3 for ir ( so you can control the sounds with the remote.)
on the other side i solderd the power and signal
Thanks, GREAT pics! Of course the one thing I didn't keep was that connector from the main board... I should still be able to figure it out. Also I want to use the EZ-B software rather than the remote so we'll see how that goes! Thanks again!