So I see a lot of wall-e's around
That made me thinking, it's time to show my wall-e
I started with the small wall-e ( the interactive )
What i learned from him i put in the big wall-e ( a U-command )
I used the old board from the wall-e for the sounds.
made the bot in 2 parts the upper half is full with servos..... and a sensor
And off course a good accu-pack is used for hours of fun ( 2,5 to be sure )
And that all together in a small compartment
So i proud show you all my wall-e and a lot of thanks to DJ ,radmeck and bret.tallent for helping me!!!
By Pabi!o
— Last update
Discover more robots
Ezang's Roman The Robot
Roman the Robot using Synthiam ARC with EZ-B v4, Arduino and servos for articulated arms, grippers, camera pan,...
Tonzatonka's Inmoov 3D Printed Robot
InMoov robot build: lower and mid torso progress, NeoPixel ring installation, weighing Arduino UNO vs Nano for tight...
Rb550f's Brookstone Ezb Teleprescence Robot
Broostone Rover 2.0 telepresence robot with 7" Android tablet, teflon anti-tip sliders, servo-based stabilization...
Hope you can see it in the picture. What i did was use the old connector from the main board to the small extension board
I split those is 2 groups one for the record-play-button to make a sound the other 3 for ir ( so you can control the sounds with the remote.)
on the other side i solderd the power and signal
Thanks, GREAT pics! Of course the one thing I didn't keep was that connector from the main board... I should still be able to figure it out. Also I want to use the EZ-B software rather than the remote so we'll see how that goes! Thanks again!