cE9s4PsOgeBQIORwjd5!~~60_1-634818020230156250.jpg)
BO)Lupuc4g~~60_35-634706297915000000.jpg)
LupbT6!~~60_35-634706298769375000.jpg)
C5j!~~60_35-634655044863125000.jpg)
C5j!~~60_35-634659603510781250.jpg)
C5j!~~60_35-634651704046230469.jpg)
This project has evolved some , the basic rundown is I'm modding two Omnibots , one a regular the other a larger 2000 model. I will have two ezb kits , rad base idea was thrown out because of so much noise but could go back on the table if the omnibot drivetrain is too weak to pull it.
By jstarne1
— Last update
Discover more robots
Leversofpower's Roboquad Redux
Hack Wowee Roboquad for custom control, no remotes, IR codes, waiting, version issues or millisecond delays
Ezang's My New Crane Robot Video Below
New crane robot built with Servo City parts, dual servo blocks for strength and a servo winch pulley; photos and video...
Rb550f's Moshi Is Alive
EZB 4 in MOSHI droid: aluminum internal frame, Sharper Image drive base with quiet 4-inch wheels, Bluetooth audio and...
Wow Josh! This is looking super good! Are you going to make a hinged door so you can get at stuff without taking it totally apart?
I plan on getting access through the back. Unscrewing the back of the torso would also open up thr back of the torso riser.
dont you have it fiberglass, and have a standoff in the center
Josh,
It look awesome....
Yes it is fiberglassed , its difficult to explain but the back half of the torso will also be attatched to the back of the riser . I will be able to unscrew the back half and it comes off to expose everything. I planned on using all Allen screws. Anyways I will do some more work today.
thats mostly my favorate type of screws to use,about 90 % of my projects use them ,and it looks closer to a robot design ,then plain old flats or pan screws,my favorate tool ,besides my dremel is my complete set of tap and die
Ok continueing the riser connections...
I spot epoxied the corners to hold the top in place. I'm letting it cure now but it usually takes about 30 minutes for this 5 minute epoxy lol.
I want these pieces to sandwich together as flush as possible. To do this I cut knotches so the ply would recess into the plastic.
While the other piece is curing I trimmed the wood so that it flushes into the bottom of the base. In a few minutes I will tape off the edges and epoxy the edges from the inside.