cE9s4PsOgeBQIORwjd5!~~60_1-634818020230156250.jpg)
BO)Lupuc4g~~60_35-634706297915000000.jpg)
LupbT6!~~60_35-634706298769375000.jpg)
C5j!~~60_35-634655044863125000.jpg)
C5j!~~60_35-634659603510781250.jpg)
C5j!~~60_35-634651704046230469.jpg)
This project has evolved some , the basic rundown is I'm modding two Omnibots , one a regular the other a larger 2000 model. I will have two ezb kits , rad base idea was thrown out because of so much noise but could go back on the table if the omnibot drivetrain is too weak to pull it.
By jstarne1
— Last update
Discover more robots
Kenny's Radio Shack Robie Meets Roomba
Convert a vintage 1984 Radio Shack Robie into a Roomba-mounted retro cleaning robot with ez-b, camera, and custom arms.
Sudo's Project Shogun
Shogun humanoid: 15in bioloid-based EZ-B robot with 26 DOF, wall-powered, stands and waves; progress, photos and...
Jstarne1's Mr Freeze Costume Controlled By Android Phone...
App-controlled Mt Freeze suit with blue coolant hoses, LEDs, EL-wire-wrapped gun, illuminated mask and phone chest...
Wow Josh! This is looking super good! Are you going to make a hinged door so you can get at stuff without taking it totally apart?
I plan on getting access through the back. Unscrewing the back of the torso would also open up thr back of the torso riser.
dont you have it fiberglass, and have a standoff in the center
Josh,
It look awesome....
Yes it is fiberglassed , its difficult to explain but the back half of the torso will also be attatched to the back of the riser . I will be able to unscrew the back half and it comes off to expose everything. I planned on using all Allen screws. Anyways I will do some more work today.
thats mostly my favorate type of screws to use,about 90 % of my projects use them ,and it looks closer to a robot design ,then plain old flats or pan screws,my favorate tool ,besides my dremel is my complete set of tap and die
Ok continueing the riser connections...
I spot epoxied the corners to hold the top in place. I'm letting it cure now but it usually takes about 30 minutes for this 5 minute epoxy lol.
I want these pieces to sandwich together as flush as possible. To do this I cut knotches so the ply would recess into the plastic.
While the other piece is curing I trimmed the wood so that it flushes into the bottom of the base. In a few minutes I will tape off the edges and epoxy the edges from the inside.