Switching Polarity To A Dc Motor

Question

Hello everyone; I'm assume it is possible, I need to have the EZ-b control a dc motor to the left and to the right, by switching polarity, between neg and pos,,,is that easy to do?

thetechguru · Answer

To control a DC motor you need an H-bridge motor controller. They can all switch direction, most can control 2 motors. Start with how many amps your motor draws at stall, and we can advise on what controller you need. Alan

RR333 · Answer

Thanx Alan. I have an H bridge for the drive motors , I only have a small dc motor that only needs to move lest to right, not 360.

thetechguru · Answer

Still needs an H-bridge. EZ-B (or any microcontroller) drive servos natively because servos have little h-bridge contoller boards built in. To drive a motor, you need a motor controller (could do it with a relay, but then no polarity or speed control). If you only want to go left or right a specific distance and not continue rotating, then replacing the motor with a servo is probably your best bet since it also has the potentiometer and feedback circuit to read position built in. Recreating that for an existing motor will cost far more than just buying a servo. Alan

RR333 · Answer

Hmmm, maybe I should switch to a servo

RR333 · Answer

Ok, 5Volt,,, one small DC Motor , is there any H-Bridges that only control one small motor?

CardboardHacker · Answer

eBay will be your best friend. I don't know of any.

RR333 · Answer

Of Course I can use a dual H-Bridge and use the second connection for something else?

thetechguru · Answer

Quote: Of Course I can use a dual H-Bridge and use the second connection for something else?  Yup. Note, with an H-bridge, it isn't the volts, it is the amps that matter. A small 5v hobby motor is probably fine with a cheap 2amp H-bridge, but if you have the specs of the motor, you should check. Alan

RR333 · Answer

Thanx, and sorry for all the Newbie questions. I appreciate the help:)

thetechguru · Answer

We were all newbie's once. Some of still are on some topics Alan

RR333

Upgrade to ARC Pro