Adc ?

Question

Having a problem reading adc Using the following script if (adc(adc0) > 10 ) servo(d1,29) ----------------------- adc0 shows full 5.volts but no change in servo value ? am I using incorrect commands ?

winstn60 · Answer

Possibly fixed now with the latest version Here

Bravia · Answer

@winstn60 Thanks for reply Downloaded latest version , but no success the "wait" command works ok ? Pat latest update Works but is not reading values properly confused

DJ Sures · Answer

I've tested this and it works. What are you experiencing?

Bravia · Answer

at present my script reads if (adc(adc0) > 10 ) servo(d1,29) ---------------------------- voltage 5v on adc0 graph but servo does not register in debug same in < ----------------------- getadc(adc0) reads value ok

DJ Sures · Answer

The documentation is incorrect. It is GetADC(adc0)

Bravia · Answer

Thanks Dj Sorry I may not be explaining it clearly --------------------------------------------------------------------- This is the script I entered GetADC(adco) If (ADC(ADC0) > 5) Servo(d1, 29) when I run this is the debug reply Start GetADC(adc0) 134 If (ADC(ADC0) > 1) Done as you can see adc value is 134 , Get command responds ok but " If " Statement does not ---------------------------------------------------------------------------- script two example GetADC(adc) If (ADC(ADCO) < 1) servo(d1,29) When I run this is the debug repy Start GetADC(adco) 134 If (ADC(ADC0) < 1) servo(d1,29) Done Get, responds with correct value , but " iF " statememt even though its not true , it moves the servo Hope I have outlined it a little clearer pat

DJ Sures · Answer

Again, the script manual was incorrect for the IF condition. The syntax is
 if (GetADC(adc0) < 1) print("It is less than one")

Get the latest ARC and notice the manual has been updated. The manual was incorrect. The proper command is GetADC().

Bravia · Answer

Thank you Dj Dowloaded update and entered new commands all works very well. excellent Take the remainder of the day off ! Ez-b is no 1 nothing comes near. Pat

DJ Sures · Answer

Hehe, thanks Bravia

Bravia

if (adc(adc0) > 10 ) servo(d1,29)

Upgrade to ARC Pro