It's just a concept right now but I wanted others to see that the scale doesnt quite match. Right now its just stacked on there and neck is a little too long.
By Troy
— Last update
Discover more robots
Recon's Development Of Autonomous Navigation Robot
Autonomous navigation robot on Roli Rover using EZ-Builder and RoboRealm, demoed as a final-year project; tutorial...
Hstud's Hunters1st Robot Sam
DIY robot S.A.M. built by 8-year-old Hunter using EZ-Robot v3 and simple parts, dollar-store body, PVC arms, LEDs and...
Fxrtst's Quantum Lift- Model CR-99
4WD sci-fi vehicle drive with EZ-Robot 360 servos, independent 4-wheel steering, mobile app control and IO Tiny; tight...
Um ok - so anyways - can't wait to see that claw running on 12 volts. I bet it will run very quick.
motors might burn out on 12 volts,if a servo motor,most are 5 volts some 6 volts and some 7.4 volts so i would be very carefull
He's using motors I sent him.plus I.have spares. They are rated 3 to 12 volts
I may run them 7.4 if they test out at a good speed.
If you do 12v you can always dial back pwm on the controller.
Thanks Josh I will probably try that.
Hey GC - I really like the way you have brought that head to life with the blink, eye roll and Jaw. There is an art to bringing life to Robots and those mechanical brush strokes of yours are great.
if they are rated ay 3 to 12 volts then they may be ok,,BUT running the motors at more the rated voltage ,like a 3 volt to 12 volts might be set for 7.4 volts it wont run very efficiently running at 12 volts plus the second is running it at max the voltage it will burn out a lot faster