It's just a concept right now but I wanted others to see that the scale doesnt quite match. Right now its just stacked on there and neck is a little too long.
By Troy
— Last update
Discover more robots
Lars1989's Omnibot 2020 - The Next Generation
Revive Omnibot 2000 with an ez-robot kit and L298N motor controller; add small servos for arms and test a 6V 5Ah gel...
Justinratliff's Jd Backpack
JD backpack mockup anchors into JD's middle slot with male clip, two top posts, dual rear mounts, wire access and switch...
Andy's Happy Holidays
Holiday wish from Antonn
Um ok - so anyways - can't wait to see that claw running on 12 volts. I bet it will run very quick.
motors might burn out on 12 volts,if a servo motor,most are 5 volts some 6 volts and some 7.4 volts so i would be very carefull
He's using motors I sent him.plus I.have spares. They are rated 3 to 12 volts
I may run them 7.4 if they test out at a good speed.
If you do 12v you can always dial back pwm on the controller.
Thanks Josh I will probably try that.
Hey GC - I really like the way you have brought that head to life with the blink, eye roll and Jaw. There is an art to bringing life to Robots and those mechanical brush strokes of yours are great.
if they are rated ay 3 to 12 volts then they may be ok,,BUT running the motors at more the rated voltage ,like a 3 volt to 12 volts might be set for 7.4 volts it wont run very efficiently running at 12 volts plus the second is running it at max the voltage it will burn out a lot faster