It's just a concept right now but I wanted others to see that the scale doesnt quite match. Right now its just stacked on there and neck is a little too long.
By Troy
— Last update
Discover more robots
R2D2's Robot Navigator
Navigator pocket robot: aluminum riveted frame, 11.1V LiPo to 8V regulator for EZ-B, minimalist ping-sensor navigation...
Rickymahk2013's Mark 1 Robot
Develop robots with Synthiam, build the Mark 1 DIY robot, publish a DIY book and showcase projects at international...
Canadian's Giant Robot Project With Ez-Robot Board
Giant outdoor robot on Wall-E base using EZ-Robot board and Sabertooth 2X25 RC control; wheelchair drivetrain, planned...
Um ok - so anyways - can't wait to see that claw running on 12 volts. I bet it will run very quick.
motors might burn out on 12 volts,if a servo motor,most are 5 volts some 6 volts and some 7.4 volts so i would be very carefull
He's using motors I sent him.plus I.have spares. They are rated 3 to 12 volts
I may run them 7.4 if they test out at a good speed.
If you do 12v you can always dial back pwm on the controller.
Thanks Josh I will probably try that.
Hey GC - I really like the way you have brought that head to life with the blink, eye roll and Jaw. There is an art to bringing life to Robots and those mechanical brush strokes of yours are great.
if they are rated ay 3 to 12 volts then they may be ok,,BUT running the motors at more the rated voltage ,like a 3 volt to 12 volts might be set for 7.4 volts it wont run very efficiently running at 12 volts plus the second is running it at max the voltage it will burn out a lot faster